Radified Community Forums
Rad Community Technical Discussion Boards (Computer Hardware + PC Software) >> Norton Ghost 2003,  Ghost v8.x + Ghost Solution Suite (GSS) Discussion Board >> Automating Ghost 10

Message started by Joe on Dec 12th, 2005 at 12:22pm

Title: Automating Ghost 10
Post by Joe on Dec 12th, 2005 at 12:22pm
Is it possible to run Ghost 10 from the command line? I've not seen anything in the documentation about this for either Ghost 9 or Ghost 10. I have an IOGear external USB drive with three buttons. This allows me to execute a commnd for each button. What I'd like to do is run a Ghost 10 backup script when one of the buttons are pressed. This would give me three possible backup scripts. I could do this if I can run Ghost from the command line and know when the backup scripts are stored (assuming there are backup scripts). I could do this with True Image 9 but I don't really like True Image that much.

Title: Re: Automating Ghost 10
Post by Pleonasm on Dec 12th, 2005 at 1:10pm
Ghost 10 supports Maxtor OneTouch Integration (see page 18 in the Norton Ghost 10.0 User’s Guide), and so it would seem that you should be able to do the same with your external hard disk drive.  Unfortunately, the User’s Guide contains no instructions on how to configure this “one button backup” feature with a Maxtor hard disk drive.

Title: Re: Automating Ghost 10
Post by Rad on Dec 12th, 2005 at 1:15pm
If & when you get that figured out, I think it might be a nice addition to the Rad Ghost guide .. a little step-by-step "how-to...".

Radified Community Forums » Powered by YaBB 2.4!
YaBB © 2000-2009. All Rights Reserved.