| Radified Community Forums | |
|
http://radified.com/cgi-bin/yabb2/YaBB.pl
Rad Community Technical Discussion Boards (Computer Hardware + PC Software) >> Norton Ghost 2003, Ghost v8.x + Ghost Solution Suite (GSS) Discussion Board >> Searching for RAMDISK drive letter. RAM drive not found http://radified.com/cgi-bin/yabb2/YaBB.pl?num=1334356997 Message started by wp on Apr 13th, 2012 at 5:43pm |
|
|
Title: Searching for RAMDISK drive letter. RAM drive not found Post by wp on Apr 13th, 2012 at 5:43pm
i created a set of two floppies using gss 2.5.
PXE and UNDI OK, but i got error message Searching for RAMDISK drive letter. RAM drive not found! suggestions please |
|
Title: Re: Searching for RAMDISK drive letter. RAM drive not found Post by NightOwl on Apr 14th, 2012 at 8:58am
@ wp
Quote:
Open the *config.sys* on the boot floppy with Notepad. Copy and paste the content to this forum thread. Do the same for *autoexec.bat* so we can see what's being loaded during the boot process. Also, you could press F8 right when the system beeps and says it's loading the OS--if you hit the F8 key at the right time, you will get a DOS screen that allows you to select *step-by-step* loading of each of the lines in the boot files one at a time and you can see any error messages. Is there a line that is supposed to load a *RAMDISK*? What happens after that line is executed? |
|
Title: Re: Searching for RAMDISK drive letter. RAM drive not found Post by wp on Apr 15th, 2012 at 12:46am
thank you.
you got it right. config.sys did not have ramdisk.sys line in it. i found an earlier boot floppy i had made and copied the ramdisk.sys line from it. works well now. i was concentrating on autoexec.bat and i forgot about config.sys |
|
Radified Community Forums » Powered by YaBB 2.4! YaBB © 2000-2009. All Rights Reserved. |